A board that shows the movement direction on a circle and a four digit display.

This board is intended to be used on an #ArduOne board starting from version 2.2.0 . This last version of ArduOne has a multiple of 2.54 mm as distance between the connectors.
Developing steps:
12.09.2023: Board development and test of the LED circle.
As can be seen from the schematic The circuit consists of two 74HC154 each one connected to a set of 16 LED for a total of 32 LED along the whole circle. A not ports acts as chip selector and its inputs becomes thus the 5th bit of the LED selector 5 bit digit. In the center of the circle an HDLX2416 alphanumeric display should show the angle in tenth of degrees, so a number that goes from 0 to 3600 deci-Degrees. This is also the angle´s resolution as it comes from the GPS receiver´s stream. The alphanumeric display should, at the end, send some scrolling messages like; “No movement detected” or “No signal from satellites”.
The assumption of this project is that I should be able to extract from the data the direction of movement. This is not so intuitive because it assumes that the antenna itself makes internally some calculations. We will see …